The Logfit™ Prosthetic System for CAMLOG® Implants

Making Implant Prosthetics Easier and More Efficient

The Logfit™ prosthetic system now makes CAMLOG® implant prosthetics even easier and more efficient through its use of prefabricated components. The standardized clinical and technical procedure means lower cost in time and money for both dentist and dental technician. Fabrication of the prosthesis is similar to that for conventional crowns and bridges.

Since the system works on the principle of modularity, it comes with a minimum of components. These include color-coded abutments, impression caps, laboratory analogs, and burn-out plastic copings for crowns and bridges. Abutments are available in two gingival heights (0.8 mm and 1.5 mm) for implant diameters 3.8 mm, 4.3 mm, 5.0 mm, and 6.0 mm.

The single-unit Logfit™ impression cap is simply snapped onto the screwed abutment in the mouth and ensures a precise transfer. The snap-on mechanism holds the analog firmly in position for the wax-up. An O-ring on the analog provides an excellent grip for the burn-out plastic copings for crowns and bridges during the wax-up. The three surfaces on the abutment permit the plastic coping, crown, and the final restoration to be centered exactly in position and provide antirotational stability. Because of the precision fit between the Logfit™ plastic copings and the analogs, no corrections of the inside configuration and the margin are required after casting. The precisely prepared plastic copings allow for a defined cementation gap and thereby ensure the exact seating of the reconstruction.